太阳能路灯控制器是路灯的“控制中心”，所有的线都汇聚于此，初次接线的时候一般都按先光源，然后蓄电池，最后电池板的接线顺序。 

先将灯具、蓄电池、电池板所有的正极汇集到一起然后接在控制器的+号所对应的那根线上。 

然后把光源的负极接到控制器上灯泡负极所对应的那根线上。 

之后把蓄电池的负极接到控制器上蓄电池负极所对应的那根线上，此时光源会亮起来，表明光源和蓄电池都已正常工作。 

再后将电池板的负极接到控制器上电池板负极所对应的那根线上，过一会，光源会自动熄灭（因为当电池板负极接上以后，整套系统就通了，太阳能电池板产生电压，控制器会自动由放电状态转为充电状态），这表明电池板也成功接好，系统正常工作了。 

最后将电线整理好，确保所有接头用绝缘胶布裹好，并在外面包一层防水胶布，最后把控制器和线放进灯杆内，固定好，并关好门子。

The solar street lamp controller is the "control center" of the street lamp. All wires converge here. The initial wiring is generally in the order of light source, battery and battery panel.

First gather all the positive poles of lamps, batteries and battery boards together, and then connect them to the line corresponding to the + sign of the controller.

Then connect the negative pole of the light source to the line corresponding to the negative pole of the bulb on the controller.

Then connect the negative pole of the battery to the line corresponding to the negative pole of the battery on the controller. At this time, the light source will light up, indicating that both the light source and the battery have worked normally.

Then connect the negative pole of the battery panel to the line corresponding to the negative pole of the battery panel on the controller. After a while, the light source will automatically go out (because when the negative pole of the battery panel is connected, the whole system will be connected, the solar panel will generate voltage, and the controller will automatically change from discharge state to charging state), which indicates that the battery panel is also successfully connected and the system works normally.

Finally, arrange the wires, ensure that all joints are wrapped with insulating tape, and wrap a layer of waterproof tape on the outside. Finally, put the controller and wire into the lamp pole, fix it, and close the door.